Blaster Scope STL Files - 0.49" Display

Blaster Scope STL Files - 0.49" Display


    These STL Files are deigned to house the SCTroniX Electronics Kit with a 0.49" OLED Display Module


    STL Parts and Printing Instructions:

    6 Parts to Print

    • Part 1: Main Body Back - Print with 30% Infill with Supports.
    • Part 2: Main Body Front Print with 30% Infill with Supports.
    • Part 3: Lens Cap - Print with 30% Infill with Supports.
    • Part 4: Front End - Print with 30% Infill with Supports. (Requires 3 x M2 x 6mm Screws to attach to the Main Body)
    • Part 5: Laser LED Holder - Print with 30% Infill with Supports. 
    • Part 6: Electronics Holder - Print with 30% Infill with Supports. (2 Designs - One for DFRobot Beetle the other for a Seeeduino XIAO)

    Features:

    • Simple to Assemble 
    • Designed Specifically for SCTroniX Scope Electronics.


    Please Note: Parts will require sanding to finish and make some parts fit snug. Remember to allow room when fitting together for the thickness of the paint.


    Preparation Instructions:

    To achieve a high quality finish on the prop, these are the steps needed.

    This is a time consuming process, but the more preparation you do the better the final finish.


    Sand: Use 800 grit sandpaper for the first sanding.

    Sand: Use 240 grit and finish with 1200 grit wet and dry sandpaper until smooth - (Optional)

    Paint: Filler Primer.

    Fill: Fill and small print lines or gaps with fine filler.

    Sand:  Final sanding with 1200 wet & dry.

    Paint: With Primer then the Colour of your choice.

    Weathering - (Optional)

      All parts available in the shop (I don't sell batteries)


      Electronics Needed to make the Animated Scope Display:

      1. DFRobot Beetle or Seeeduino XIAO Microcontroller
      2. SCTroniX Arduino Code
      3. 0.49" OLED Display Module
      4. 2 x 6 x 6 x 5mm Tactile Switches (One for turning the laser on/off the other to change the screen display)
      5. 5V Red Laser LED Diode
      6. 3 x 1.25mm 2 Pin JST Male & Female Connectors (Two for the switches and one for power)
      7. 1 x 1.25mm 4 Pin JST Male & Female Connector (For the OLED Screen)
      8. 2 x 10K Resistors (For the two switches)


      Here is a Video of the Prototype in Action


      The Electronics can be purchased either as a kit or fully assemble (The 3D printed parts on the fully assembled version will require sanding)


      Item is a digital download of the STL files in Zipped format:

      1 x E-11 Blaster Scope STL Files for a 0.49" Display Screen.


      Please Note: DIY electronics are meant for those with basic electrical knowledge and soldering skills. DIY electronics do not include lead wires, instructions or warranties.

      Before placing your ordering, please make sure you are fully aware of the shipping policy outlined here: Shipping Policy



      Write a review

      Please login or register to review

      • Product Code:GE00134
      • Availability:99

      • { price }}


      Related Products